Home Uncategorized What should be checked about environmental protection inspection?

What should be checked about environmental protection inspection?

by admin

contents of environmental protection inspection:

1. The auxiliary materials with powder and relevant coal-fired boilers shall be sealed up while producing accessories

2. Products with noise and strong smell should also be rectified

3. Manufacturers without business license and non-standard need to be reorganized

4. Check the potential fire safety hazards in passing

5. Check the fake and shoddy and counterfeit brands

6. Secretly discharge wastewater

7. Emit pungent gases such as paint smell

8. Low frequency noise or excessive noise

9. Dust pollution

10. The EIA was not publicized

11. No environmental protection approval procedures

12. There are hidden dangers in the operation of the motor unit

13. Illegal construction

14. Privately set up concealed pipes for sewage discharge

15. Coal cinders float everywhere

16. There are problems in pit excavation and landfill of paper slag

17. No wastewater recovery system

18. Failure to apply for water intake permit

19. Operation without lighting

20. Storage of other wastes in ponds without anti leakage measures

21. Poor and old pollution control facilities

22. The smoke emission concentration exceeds the standard

23. The accumulated garbage in the plant area was not treated in time

24. Failure to apply for approval of environmental impact assessment documents

25. The pollution control facilities have not been accepted by the environmental protection department

26. The pollutant discharge permit has expired

27. Illegal production

28. The COD of the filter exceeds the standard

29. No pollutant discharge permit

➤ waste gas pollution inspection

check the operation status, historical operation, treatment capacity and treatment capacity of waste gas treatment facilities

inspection of waste gas generated by combustion of boilers, petrochemical and chemical industries

check whether the treatment methods of combustible organic waste gas continuously generated by chemical and petrochemical enterprises are reasonable, and whether the treatment methods of recycling or incineration are adopted, and whether the treatment of combustible organic waste gas intermittently generated by incineration, adsorption or combined processes are reasonable

check the verification procedures and performance indicators of boiler combustion equipment, check the operation status of combustion equipment, check the control of sulfur dioxide and nitrogen oxide

pollution sources of process waste gas, dust and odor

check whether the emission of waste gas, dust and odor meets the requirements of relevant pollutant emission standards

check the recycling of combustible gas

check the environmental protection measures for transportation, loading, unloading and storage of toxic and harmful gases and dust

air pollution prevention and control facilities

dust removal, desulfurization, denitration and other gaseous pollutant purification systems

exhaust outlet

check whether the polluter has built a new exhaust funnel in the area where new exhaust funnel is prohibited

check whether the height of exhaust funnel meets the provisions of national or local pollutant emission standards

check whether sampling holes and sampling monitoring platforms are set on the exhaust funnel

check whether the exhaust port is set according to the required specifications (height, sampling port, signboard, etc.), and whether the required exhaust gas is installed and used according to the environmental protection department

unorganized emission source

(1) for the discharge points of unorganized discharge of toxic and harmful gases, dust and smoke, if it is possible to achieve organized discharge, check whether the pollutant discharge unit has carried out remediation and implemented organized discharge

(2) check whether dust prevention measures have been taken in the coal yard and construction process

(3) monitor at the enterprise boundary to check whether the unorganized emission meets the requirements of relevant environmental protection standards

after checking the exhaust gas of the national sixth automobile, I bought it in October 19. The environmental protection personnel looked at the instrument panel on the car and said it was unqualified,

go to Baidu app to view
Answer

 the environmental protection test items after decoration are: 

 test items 

 main tests: radon, ammonia, formaldehyde, benzene, TVOC 

 [radon] radon is a radioactive inert gas, colorless and tasteless. It exists in cement and sand

 harm: radon pollution, an indoor pollutant, is second only to smoking, and is the second inducement of lung cancer

 [formaldehyde] formaldehyde has a strong smell. Man made panels use adhesives and contain formaldehyde

 hazard: severe irritation of respiratory tract will occur after inhaling high concentration formaldehyde. Direct skin contact with formaldehyde can cause dermatitis. Regular inhalation of a small amount of formaldehyde can cause chronic poisoning

 [benzene] benzene is a colorless liquid with special aromatic smell

 harm: long term inhalation of benzene can lead to aplastic anemia

 [TVOC] total volatile organic compounds (TVOC), mainly from coatings, adhesives, etc

 harm: TVOC can cause dizziness, headache, drowsiness, weakness, chest tightness and other symptoms

 [ammonia] ammonia is very soluble in water, which has fast effect on eyes, throat and upper respiratory tract and strong irritation

 harm: exposure to low concentration ammonia for a long time will cause laryngitis, hoarseness and pulmonary edema

 ① according to the code for indoor environmental pollution control of civil building engineering GB50325-2001 (2006 Edition), it is recommended that only three items be inspected for individual houses: formaldehyde, benzene and total volatile organic compounds TVOC. ② According to the indoor air quality standard (GB /t18883-2002), it is recommended that only six items should be inspected for individual houses: formaldehyde, benzene, total volatile organic compounds TVOC, toluene, xylene and ammonia

 ① according to the code for indoor environmental pollution control of civil building engineering GB50325-2001 (2006 Edition), it is recommended that only three items be inspected for individual houses: formaldehyde, benzene and total volatile organic compounds TVOC. ② According to the indoor air quality standard (GB /t18883-2002), it is recommended that only six items should be inspected for individual houses: formaldehyde, benzene, total volatile organic compounds TVOC, toluene, xylene and ammonia

13 more

1. EIA report file
2. Pollutant discharge permit file
3. Environmental protection related accounts, including solid and hazardous wastes, sporadic wastewater transfer, environmental protection facilities and other accounts
4. On site pollution control facilities and equipment

Related Posts

Leave a Comment